1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
General Restoration Questions
Tgace459
Member
***
Posts: 130
Threads: 25
Joined: Apr 2016
City: Buffalo NY
#16

04-25-2017, 03:14 PM
I did use a sanding block on the sides.
(This post was last modified: 04-25-2017, 03:16 PM by Tgace459.)
Find
Kenneth F. Besso Jr.
Senior Member
****
Posts: 667
Threads: 11
Joined: Sep 2014
City: Bellmawr, NJ
#17

04-26-2017, 10:22 AM
looks like they are HIGH spots,,,, ( I ) would just stain them over again,,,and call it done
Find
Tgace459
Member
***
Posts: 130
Threads: 25
Joined: Apr 2016
City: Buffalo NY
#18

04-26-2017, 11:36 AM
Lighting and angle makes a difference in how obvious these splotches are. From some angles they all but disappear and from others they are obvious.
Find
adamrobertg
Junior Member
**
Posts: 21
Threads: 7
Joined: Apr 2017
City: Weston, CT
#19

05-01-2017, 05:24 PM
I had a few spots like that when working on my 38-8 cabinet. I sanded lightly with 800 grit sandpaper to ensure it was smooth, and just hoped toner would cover it. It did, looks fine now- you can't even tell.
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM

[-]
Who's Online
There are currently 7920 online users. [Complete List]
» 1 Member(s) | 7919 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration