Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

the philco radio story
#1

Hello everyone,
Here is a great video on the story of Philco.


https://www.youtube.com/watch?v=kanPsUDyKrU&t=132s
#2

Thanks, that was something else.  I was quite impressed with the size of the soldering irons and how quickly they made each connection.  I didn't know Philco made their own hardware down to the nuts and bolts.  Quite an impressive factory.
#3

Awesome video loved to see the old production knowing how far we have come from there
#4

Great vid, viewing over and over. Seems back then you get to wear better threads the further up the chain of command you obtained. Bet their necks suffered from the tedium, especially the person doing the socket soldering - wonder the heath problems from that. So, according to the vid, 'Balanced' was what you can achieve from mass production, the best it can be.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Delco car radio Peko vibrator converstion issues
Rich, There is an Australian website (Cool386.com) that has much useful info regarding repair and restoration of vibr...Joe Rossi — 07:29 PM
Jackson 715 not working
Mrfixr55, its working now. I cleaned the switches and sockets with spray cleaner. Thanks for helping on this one.daveone23 — 06:26 PM
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM

[-]
Who's Online
There are currently 3513 online users. [Complete List]
» 4 Member(s) | 3509 Guest(s)
AvatarAvatarAvatarAvatar

>