Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

I need the technical manual model 46-806
#16

HI Eliot Ness, thank you very much for your reply and help try to follow your recommendations to see if I succeed.
regards
#17

have you tried
http://videokarma.org/

or

http://www.vintage-radio.net/forum/index...0f8dc69cbd&

sam

Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2
#18

Hello san, thank you very much for your answer, try to see if I succeed in these forums.
Thank you very much again and Greetings
#19

Hello Eliot Ness, say:

"This radio was not sold in the United States so not not many collectors own one of these".

But I have seen in Radiomuseum, this radio was manufactured in the United States.

http://www.radiomuseum.org/r/philco_46_806.html
#20

I have several Philco radios that were made in the US of A, but they were not sold there. Just because its made in America doesn't mean it was made for the American market...

There are no personal problems that can't be overcome with the liberal application of high explosives
#21

Thank you very much once again for your answer kiwi_steve.
You're right in what you say, keep looking to see that find, and if not, as you say, we must make a specific support for a loudspeaker located.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have been playing the radio for a while now and doing well. Turned it on today and all I got was a whole lot of noise....dconant — 09:39 AM
Rusty Tuning Condenser
Thanks guys. I think I'll give the Naval Jelly a try since I can better control where it goes.dconant — 09:23 AM
Philco Model 80 Transformer resistance
Just forget this number, it is useless anyway. Simply proceed with your project.morzh — 10:08 PM
Philco Model 80 Transformer resistance
My $0.02 is that it is a misprint. I tried to look up the value for the similar 84 and 37-84, and ther is no resistance...MrFixr55 — 09:51 PM
Philco Model 80 Transformer resistance
Thanks for the quick reply! Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM
Philco Model 80 Transformer resistance
I have a feeling the primary winding on the power transformer is bad. My resistance reading on the primary side is 9 ohm...Mike L — 07:48 PM
Rusty Tuning Condenser
I would try Naval Jelly and use a soaked pipe cleaner to get it where it needs to go.RossH — 06:56 PM
38-10T chassis Restoration begins
Hello Dconant , they sold mica to use as a insulator between transistors and their heatsinks too. Rob I will remove th...radiorich — 02:52 PM
38-10T chassis Restoration begins
Thanks for the info guys. I always wondered why the use of mica. Now I know.dconant — 01:52 PM

[-]
Who's Online
There are currently 3824 online users. [Complete List]
» 2 Member(s) | 3822 Guest(s)
AvatarAvatar

>