Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 50-T702
#61

Yeah, the HV rectifier has been replaced. The HV is up where it should be about 5Kv. The picture is very viewable in a semi-dark room.

Crist
#62

Arran, that is interesting about the phosphor. I actually read about this recently in an old TV book. It mentioned that the phosphor can even degrade to the point that you can actually see into the tube from the front! Well, no matter if it is low emission or gas, the tube is tired. But, at least it is still giving service, and there is something to be said for that. Crist, that chassis is really looking nice! A little patience will pay off in locating a better tube. It took me over 30 years to find a NOS tube for one of my sets that I could afford. Mine had a line burned across the screen from a vertical sweep failure. That really wrecks an otherwise good picture! Icon_neutral

If I could find the place called "Somewhere", I could find "Anything" Icon_confused

Tim

Jesus cried out and said, "Whoever believes in me , believes not in me but in him who sent me" John 12:44
#63

(05-19-2016, 11:19 PM)Madmurdok Wrote:  Arran, that is interesting about the phosphor. I actually read about this recently in an old TV book. It mentioned that the phosphor can even degrade to the point that you can actually see into the tube from the front! Well, no matter if it is low emission or gas, the tube is tired. But, at least it is still giving service, and there is something to be said for that. Crist, that chassis is really looking nice! A little patience will pay off in locating a better tube. It took me over 30 years to find a NOS tube for one of my sets that I could afford. Mine had a line burned across the screen from a vertical sweep failure. That really wrecks an otherwise good picture! Icon_neutral

Yeah, I'm going to be patient.  Anybody have any knobs?

Crist
#64

 If you really can't stand watching a dim 7JP4 there are some scope tubes that will work as a cheap substitute, but the phosphors are P1 rather then P4, the drawback of course is that the phosphor is green rather then white. A lot of people go the scope tube route on one of those 3'' Pilot TVs since it's all too common to find one of the original 3KP4s with an open filament thanks to the goofy filament series string those sets used.
Regards
Arran
#65

Still looking for some knobs.

Crist




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Part numbers to model cross
I looked thru the documents and did not see one. Might have missed it though.Jim Dutridge — 07:16 PM
Philco 42-345 Restoration/Repair
Please tell me this was it, I replaced resistor 27 and it's playing on the broadcast band. I am afraid to change the ban...osanders0311 — 06:12 PM
Philco 42-345 Restoration/Repair
So far still no broadcast, I am posting pictures of #14 Oscillator and also a resistor #27 which connects to an XXL tube...osanders0311 — 04:02 PM
Part numbers to model cross
I believe there is that document, and I think we might have it in the Library.morzh — 03:29 PM
Philco 42-345 Restoration/Repair
Ok MrFixr55,  I have tried the DeoxIT D5 on the band switch and even though it has relieved the tension I felt when turn...osanders0311 — 11:11 AM
Part numbers to model cross
Is there a reference somewhere where you can punch in Philco part numbers and see what models those parts were used in?Jim Dutridge — 10:17 AM
Philco 42-345 Restoration/Repair
Hi OSanders, Look carefully at the band switch. Turn it slowly and "wiggle" it around the desired band. ...MrFixr55 — 12:33 AM
5U4 vs 5Z4 tubes
I think that RCA and GE introduced metal tubes in the USA in 1936.  I don't know if they were being made by RCA, GE or b...MrFixr55 — 11:20 PM
Philco 42-345 Restoration/Repair
Vlad95, Thank you for the stringing guides and wow there are so manyosanders0311 — 06:01 PM
5U4 vs 5Z4 tubes
A pre war Hallicrafters, and an early one too, very nice! 1936 is pretty early for metal tubes too, which would explain ...Arran — 05:58 PM

[-]
Who's Online
There are currently 1295 online users. [Complete List]
» 3 Member(s) | 1292 Guest(s)
AvatarAvatarAvatar

>