Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

#1

Does anyone know if you can still get theses. And some of the color codes are gone . What do you look for to order replacements .
I seen the site at the repair bench . Does Chuck sell them. Icon_rolleyes
Thanks Kent.
#2

Hi Kent

No, Chuck does not sell them, but here's a few places that do:

Mouser Electronics - http://www.mouser.com/

Radio Daze - http://www.radiodaze.com/

Vacuum Tubes, Inc. - http://www.vacuumtubesinc.com/

Jim Cross, owner of Vacuum Tubes, Inc., is another of the "good guys" in the radio hobby and is deserving of our support.

Basically, you need to know the value of your original mica caps and then order new micas that are at or as close to the original value as possible.

I think most micas have a working voltage of 500 volts DC, which is plenty for nearly any radio application. Some are rated at 300 volts DC which is still enough for many radio circuits using mica caps.

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

[-]
Who's Online
There are currently 5554 online users. [Complete List]
» 1 Member(s) | 5553 Guest(s)
Avatar

>