1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
Quick help
1230AM
Junior Member
**
Posts: 8
Threads: 3
Joined: Feb 2020
City: Louisville State, Province, Country: KY
#1

02-11-2020, 01:41 PM
At the risk of a violation - In addition to my prior Low AM Volume question, (On a Philco) I have a non-Philco radio with a Numite Condenser Cat. No. AT 8450 reading cap.8 and 450v.  Just to be clear, is this merely an 8mf capacitor?

Radio has a hum and this is the only cap not replaced.  Its a large one and I suspect this to be the issue.

Thank you and my apologies for posting a non-Philco question.....But this hopefully is generic and will be the last non-Philco question I ask.
Find
Radioroslyn
Phorum Expert
*****
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#2

02-11-2020, 01:49 PM
I would think that it's an 8mfd. An .8 would pretty small in physical size by comparison. 10mfd would be a suitable replacement as I don't know if the 8's are a common value anymore. Old school tubular 8mfd@450v would be abt 1" in dia and 2 to 3" long.
Here @ the Philco Phorum we are a non discriminatory radio phorum however we do have a special section for "other radios"
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
(This post was last modified: 02-11-2020, 01:55 PM by Radioroslyn.)
Find
1230AM
Junior Member
**
Posts: 8
Threads: 3
Joined: Feb 2020
City: Louisville State, Province, Country: KY
#3

02-11-2020, 03:32 PM
Thanks!  What you describe would be it.  Thanks again for the confirmation.
Find
« Next Oldest | Next Newest »




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
HiFi (Chifi) tube amp build - but my own design.
Tim Well...a chassis is metal. Magnetic or not, it does not matter. A transformer has some hum to it. It is natural....morzh — 08:40 PM
Shadow Meter Bulb
Ross I am not sure what current limiting effect the incandescent provides. They are two different parts of the sch...morzh — 08:31 PM
12' Philco
Bob Thanks for that photo. I have been looking for it, and I cannot find anythinmg on the web. I forgot it was here...morzh — 08:29 PM
Shadow Meter Bulb
I think after all has been said, I will use the same bulb that is specified for the dial pilot light which is a #55. I ...georgetownjohn — 07:31 PM
12' Philco
There was also this Philco! klondike98 — 07:25 PM
HiFi (Chifi) tube amp build - but my own design.
I expected a challenge and this is just part of it. But, it's also supposed to be fun, entertaining, informative and enj...TV MAN — 07:12 PM
Shadow Meter Bulb
Butting in here with a question. Since the shadow meter is connected directly to the 1st and 2nd I.F.'s wouldn't the met...RossH — 06:43 PM
HiFi (Chifi) tube amp build - but my own design.
Mike, Tim; you are about to enter the twilight zone. Doo doo doo doo, doo doo doo doo This is something alright. I'm go...RodB — 06:26 PM
HiFi (Chifi) tube amp build - but my own design.
:lol: We need to start a singing radio group! I play the guitar, so maybe get a few vocals? Anyways, Mike, I did try mou...TV MAN — 05:56 PM
HiFi (Chifi) tube amp build - but my own design.
And so does a barber shop quartet. mmmmmmRodB — 03:54 PM

[-]
Who's Online
There are currently 6473 online users. [Complete List]
» 1 Member(s) | 6472 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration