Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 60 resistor wattages?
#1

Hello all,

This is my first post. I am working on a Philco 60. I've noticed a few of you have restored this great old radio and was hoping I could get some help on the proper wattage of the resistors. As you know, this information is not given in the schematics. It was suggested by someone on the Antiqueradios forum that they routinely replace the flexible wire-wounds with 2 Watt and suggested that 2 Watts would work for all the resistors in the chassis.

Thanks,

lyle

I may not be very good, but I'm slow.
#2

Here, this might help. http://www.philcorepairbench.com/resistcompare.htm

Steve

M R Radios   C M Tubes
#3

(02-29-2012, 04:44 PM)Steve Davis Wrote:  Here, this might help. http://www.philcorepairbench.com/resistcompare.htm

Steve

Thanks, Steve

I just found the values on the Philco parts values on the PhilcoRepairBench page.

Between you and that I think I've got it.

Thanks again, Steve

I may not be very good, but I'm slow.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 3038 online users. [Complete List]
» 1 Member(s) | 3037 Guest(s)
Avatar

>