Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Anyone have a 41-608? help please
#1

I have a 41-608 that I recapped and I believe I have a cap with 1 leg in the wrong position. The unit worked after I replaced all the coupling caps and I foolishly moved one leg of one of them and now does not work. I have been over the schematic many times and can't seem to find it. This was a stupid mistake and I am fairly new to this. Anyone have one of these and can get some pictures of the underside of the chassis where the couplers are soldered? I know its a long shot but have to ask. Thanks in advance for any help. This is a wonderful radio and want to see it live again!
#2

Where is the side that is connected connected to???
Terry
#3

They are all hooked up, and according to the schemantic, correctly. I know theaudio side is working, I get a nice hum when I touch the volume control.
#4

What cap is it?
#5

Its one of the. 05s that run beside the XXL tube and the 1st. Rf tube 7b7. There is a strip of tie points and I think Its one of those.
#6

Also, this is a 122 model.
#7

Give us a reference number from the schematic for the component(s) in question, so we are starting from the same place.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM

[-]
Who's Online
There are currently no members online.

>