Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

40-95 Finish
#1

Can you tell me what kind of wood the 40-95 is made of and what kind of finish it has. Thanks.
#2

Sorry for the late reply, but...the 40-95 would have walnut veneer and a medium walnut finish overall.

Assuming you mean the 40-95T table model, the bottom trim is very dark brown, nearly black. Van Dyke Brown toning lacquer from Mohawk would be a good color choice for this trim.

Beware! What appears to be veneer inlay running vertically and horizontally from the two knobs are decals (photofinish)! Once the cabinet is stripped, those are gone forever. Stewart Schooley has a method of replicating photofinish; this is discussed here.

--
Ron Ramirez
Ferdinand IN
#3

Thanks, Ron. Is there a list of the Philcos that have this photofinish?
#4

Not that I know of. You can count on all of the smaller 1937 and 1938 Philco cathedrals and tombstones to have the photofinish on the entire front panel. Photofinishes are also used on some later models.

Alas, I have to work for a living, so that limits my time in compiling lists...

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently no members online.

>