Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

40-95 Finish
#1

Can you tell me what kind of wood the 40-95 is made of and what kind of finish it has. Thanks.
#2

Sorry for the late reply, but...the 40-95 would have walnut veneer and a medium walnut finish overall.

Assuming you mean the 40-95T table model, the bottom trim is very dark brown, nearly black. Van Dyke Brown toning lacquer from Mohawk would be a good color choice for this trim.

Beware! What appears to be veneer inlay running vertically and horizontally from the two knobs are decals (photofinish)! Once the cabinet is stripped, those are gone forever. Stewart Schooley has a method of replicating photofinish; this is discussed here.

--
Ron Ramirez
Ferdinand IN
#3

Thanks, Ron. Is there a list of the Philcos that have this photofinish?
#4

Not that I know of. You can count on all of the smaller 1937 and 1938 Philco cathedrals and tombstones to have the photofinish on the entire front panel. Photofinishes are also used on some later models.

Alas, I have to work for a living, so that limits my time in compiling lists...

--
Ron Ramirez
Ferdinand IN




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently no members online.

>