Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 38-62 restoration
#16

Bob, that radio chassis looks great. I wouldn't mess with it. Nice job on the "old lady", she should show a little of her age. As for the TV chassis, that looks terribly nice. I can't imagine doing that deep a teardown but then again, it looked like it had seen a lot of mouse activity. You are very talented.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.
#17

Thanks! That TV chassis was by far the nastiest project I've tackled so far. Under the mouse droppings, I found deep corrosion. Almost right through the chassis in areas. That's why I used primer and bondo to fill it in. The set isn't particularly valuable or anything - I just wanted to see if I could do it Icon_smile
#18

Bob,

You do really nice work. After following your You Tube videos on this same radio, it's nice to see the "book" version. I always learn something when I watch/read about your restorations.

I liked your method for fixing the cabinet break. I never would have guessed it would work so well. That radio is going to look beautiful when you're done.

Tom
#19

Thanks! I'll throw up a video on the cabinet restoration when it's a little further along.




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Made mistake & did not label connection
Hi John, I don't have this radio, but I can supply some info: Based on your pic, pins 7,8 and 1 are used together, go...MrFixr55 — 02:02 PM
New Philco Repair Bench
As far as I know, the Repairbench does not work, and has not been working in a while. Chuck (we had that campaign looki...morzh — 01:33 PM
Radio city products 664 schematic request
Need a schematic or manual for the 664. The 663 may be similar.daveone23 — 12:38 PM
New Philco Repair Bench
Thanks Gary.dconant — 12:16 PM
New Philco Repair Bench
I tried accessing the site through our library and got the same response. It's reported to our tech gurus. GaryGarySP — 11:50 AM
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM

[-]
Who's Online
There are currently 3522 online users. [Complete List]
» 5 Member(s) | 3517 Guest(s)
AvatarAvatarAvatarAvatar
Avatar

>