Posts: 65
Threads: 23
Joined: Mar 2013
City: Murray, KY
When replacing a Philco dial (this one's a model 80) what is the preferred way to attach the reproduction?
They are held on as you know by very small rivets. Drilling out the rivets is no problem but what do you use in their place? Will contact cement hold?
Thanks.
Posts: 2,353
Threads: 92
Joined: May 2010
City: Clayton, NC
If you want to avoid cracking the plastic dial, use small screws/nuts.
Posts: 15,812
Threads: 553
Joined: Oct 2011
City: Jackson, NJ
Short of what Tom's suggested, if you are set on using rivets, you have to extract the mandrel from a rivet and use the barrel flaring it gently with some tool. You cannot use a riveting tool.
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
Posts: 65
Threads: 23
Joined: Mar 2013
City: Murray, KY
(06-04-2015, 02:22 PM)TA Forbes Wrote: If you want to avoid cracking the plastic dial, use small screws/nuts.
Two good answers already. I think I'll go with the small screws and nuts. Thanks fellows.
John
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
