Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand
State, Province, Country: Indiana
The cone can be unglued from the frame. All it takes is a little acetone and a lot of patience.
An eyedropper is a big help (just make sure you never...EVER...use that eyedropper in your, or anyone else's, eye ever again!). Use the eyedropper's vacuum action to get some acetone into it, then squirt liberally all around the perimeter of the cone. You may have to do this two or three times. Eventually, the outer edge will come loose.
--
Ron Ramirez
Ferdinand IN
Messages In This Thread
RE: Philco 16B restoration - by Ron Ramirez - 07-26-2016, 12:45 PM
Users browsing this thread: 1 Guest(s)
|
|
Recent Posts
|
|
Rogers Majestic R-646
|
| Vlad;
I was just reminded of something else, I'm not sure why but many Rogers built sets do seem to have open primari...Arran — 04:40 PM |
|
Rogers Majestic R-646
|
| Thanks RpdB
I don't think there's much difference with interstage transformers of different models other than dimersion...Vlad95 — 03:27 PM |
|
Rogers Majestic R-646
|
| Vlad;
I looks like your set has the same problem that mine did, both a bad output transformer, and a bad audio inters...Arran — 03:21 PM |
|
Rogers Majestic R-646
|
| Ouch! Not often the secondary takes a hit. Wish there was a better solution. I have a good interstage transformer but it...RodB — 02:59 PM |
|
Rogers Majestic R-646
|
| By the way, the bypass you suggested is a rare solution in some circuits.
For example, this schematics solution is used...Vlad95 — 01:43 PM |
|
Rogers Majestic R-646
|
| No, you are wrong, because you did not know the details.
Unfortunately, only ONE winding out of six is intact in both t...Vlad95 — 01:14 PM |
|
Rogers Majestic R-646
|
| The output 45s are still in push-pull because the transformer secondary winding is still in the grid circuit providing o...RodB — 11:52 AM |
|
Rogers Majestic R-646
|
| Thanks RodB for the help.
But this is not a real solution to this situation, not even a temporary one. Because the firs...Vlad95 — 11:34 AM |
|
Philco Model 16 wiring question
|
|
I was going to check the voltages as you suggested and hooked it up to my dim bulb. It appears I have a short. The bul...bobclausen — 10:34 AM |
|
Rogers Majestic R-646
|
| You can bypass the interstage transformer by disconnecting the primary, connect a load resistor of about 10k - 20k to th...RodB — 09:40 AM |
|
Who's Online
|
There are currently 1008 online users. [Complete List]
» 3 Member(s) | 1005 Guest(s)
|
|
|
|
 
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
