1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
bakelite block question
murf
Senior Member
****
Posts: 668
Threads: 144
Joined: Jun 2011
City: Elko,MN.
#4

04-10-2017, 07:38 PM
After looking farther, I see there is a 4989DG that is not listed as well.
Schematic view and the parts list only show 3 blocks instead of the 6 or 7 blks that are used in the chassis.
What's up ?
Murf
Find
« Next Oldest | Next Newest »


Messages In This Thread
bakelite block question - by murf - 04-10-2017, 05:29 PM
RE: bakelite block question - by doc612 - 04-10-2017, 06:22 PM
RE: bakelite block question - by murf - 04-10-2017, 06:46 PM
RE: bakelite block question - by murf - 04-10-2017, 07:38 PM
RE: bakelite block question - by doc612 - 04-10-2017, 07:55 PM
RE: bakelite block question - by Steve Davis - 04-10-2017, 08:54 PM
RE: bakelite block question - by murf - 04-10-2017, 09:36 PM
RE: bakelite block question - by doc612 - 04-10-2017, 09:01 PM
RE: bakelite block question - by murf - 04-10-2017, 09:26 PM
RE: bakelite block question - by Radioroslyn - 04-10-2017, 09:44 PM
RE: bakelite block question - by murf - 04-10-2017, 10:07 PM
RE: bakelite block question - by Warren - 04-10-2017, 10:29 PM
RE: bakelite block question - by Radioroslyn - 04-10-2017, 10:39 PM
RE: bakelite block question - by murf - 04-11-2017, 06:44 PM
RE: bakelite block question - by Radioroslyn - 04-11-2017, 07:49 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4955 online users. [Complete List]
» 1 Member(s) | 4954 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration