Canadian Philco Model 870

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Guest
Unregistered

02-28-2010, 12:23 PM

I am new to the forum and submitted this message just before the site went down and it appears to have vanished. Please excuse me if this is a repetition!

As my second attempt at reviving an AA5 set, I am working on a Canadian Philco Model 870 which is built on a printed circuit board. I have checked all of the schematic sites known to me and have been unable to locate this model. I was wondering if anyone on the forum would know if there was an equivalent American model under a different number which I could look up.

Thank you for your help.

Joseph

« Next Oldest | Next Newest »

Messages In This Thread

Canadian Philco Model 870 - by Guest - 02-28-2010, 12:23 PM

Re: Canadian Philco Model 870 - by Ron Ramirez - 02-28-2010, 12:48 PM

Re: Canadian Philco Model 870 - by Arran - 03-01-2010, 11:49 PM

Re: Canadian Philco Model 870 - by Guest - 03-02-2010, 06:10 PM

Re: Canadian Philco Model 870 - by Arran - 03-06-2010, 11:07 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone, Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me