1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 21 sort of
Radioroslyn
Phorum Expert
*****
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#10

07-20-2018, 04:31 PM
So 21 cabinet is looking pretty good after many coats of lacquer, sanding, toning, ect. Unfortunately when I use to do leather repair I got to be pretty detail oriented, this thing has been make me nutz. Always can find little think I think I can improve on. There a few minor t/u it could use but I think I'll save that later. I need to get a few walnut markers. The lower rt frnt corner is ok the light area is a reflection.


Attached Files Image(s)
       
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
(This post was last modified: 07-20-2018, 04:32 PM by Radioroslyn.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 21 sort of - by Radioroslyn - 07-10-2018, 11:47 AM
RE: Philco 21 sort of - by OldRestorer - 07-10-2018, 04:29 PM
RE: Philco 21 sort of - by Arran - 07-13-2018, 05:09 AM
RE: Philco 21 sort of - by Radioroslyn - 07-13-2018, 11:34 AM
RE: Philco 21 sort of - by Phlogiston - 07-13-2018, 12:19 PM
RE: Philco 21 sort of - by Arran - 07-18-2018, 03:03 AM
RE: Philco 21 sort of - by Steve Davis - 07-18-2018, 09:30 AM
RE: Philco 21 sort of - by Radioroslyn - 07-18-2018, 11:12 AM
RE: Philco 21 sort of - by Steve Davis - 07-18-2018, 11:55 AM
RE: Philco 21 sort of - by Radioroslyn - 07-20-2018, 04:31 PM
RE: Philco 21 sort of - by OldRestorer - 07-21-2018, 06:16 AM
RE: Philco 21 sort of - by Radioroslyn - 07-21-2018, 09:43 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration