1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
42-350 tuning condenser. Never worked on this.
Patrick
Senior Member
****
Posts: 365
Threads: 76
Joined: Oct 2014
City: Winter Haven, FL
#1

10-30-2018, 05:27 PM
This tuning condenser has 4 gangs. But 2 are single blade (I would imagine SW and FM?). I didn't mark them when I removed them, and I'm lost as to proper hook-up.

I know the tuner is #14. One tab is connected to pin 2 of #7 (the FM oscill. trans.), one is connected to pin 7 of #7, one to C-3/C-4, and one to B-4.

But for the life of me, I can't figure out which! Can someone help?

Thanks,

Pat  

[Image: http://i1367.photobucket.com/albums/r796...ozv5t3.jpg]

[Image: http://i1367.photobucket.com/albums/r796...nzyvg3.jpg]
Find
« Next Oldest | Next Newest »


Messages In This Thread
42-350 tuning condenser. Never worked on this. - by Patrick - 10-30-2018, 05:27 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6859 online users. [Complete List]
» 1 Member(s) | 6858 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration