02-23-2019, 06:17 PM
Right, pictures:
Here is the method I used to refit the mounting bars. These suspend the radio chassis in the pull-out drawer.
I used two sizes of clear tubing (one fits within the other) to make a substitute grommet. This makes a good snug fit between the peg on each bar, and the 7/16" hole in the chassis.
Here is the method I used to refit the mounting bars. These suspend the radio chassis in the pull-out drawer.
I used two sizes of clear tubing (one fits within the other) to make a substitute grommet. This makes a good snug fit between the peg on each bar, and the 7/16" hole in the chassis.
I don't hold with furniture that talks.