Early 16B tombstone

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Early 16B tombstone

Radioroslyn
Phorum Expert

Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

05-16-2019, 03:14 PM

I have a stupid question. Would the June '34 version of the 16B use the larger (it's abt 1" or 1 1/8") of the six sided hex black knob?
https://philcoradio.com/gallery2/1935a/#Model_16B

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

Early 16B tombstone - by Radioroslyn - 05-16-2019, 03:14 PM

RE: Early 16B tombstone - by Ron Ramirez - 05-16-2019, 04:32 PM

RE: Early 16B tombstone - by Radioroslyn - 05-16-2019, 07:08 PM

RE: Early 16B tombstone - by Radioroslyn - 06-12-2019, 12:29 PM

RE: Early 16B tombstone - by Ron Ramirez - 06-12-2019, 01:59 PM

RE: Early 16B tombstone - by morzh - 06-12-2019, 02:18 PM

RE: Early 16B tombstone - by klondike98 - 06-12-2019, 11:56 PM

RE: Early 16B tombstone - by Nathan Slingerland - 06-13-2019, 10:44 AM

RE: Early 16B tombstone - by morzh - 06-13-2019, 11:27 AM

RE: Early 16B tombstone - by Radioroslyn - 06-13-2019, 01:53 PM

RE: Early 16B tombstone - by Radioroslyn - 08-16-2019, 05:29 PM

RE: Early 16B tombstone - by NostalgiaRadioTime - 08-17-2019, 12:12 AM

RE: Early 16B tombstone - by Radioroslyn - 08-17-2019, 09:59 AM

RE: Early 16B tombstone - by NostalgiaRadioTime - 08-17-2019, 11:43 PM

RE: Early 16B tombstone - by Radioroslyn - 04-08-2020, 03:51 PM

RE: Early 16B tombstone - by Radioroslyn - 04-11-2020, 08:40 PM

RE: Early 16B tombstone - by Radioroslyn - 04-15-2020, 04:02 PM

RE: Early 16B tombstone - by Nathan Slingerland - 04-15-2020, 04:03 PM

RE: Early 16B tombstone - by Radioroslyn - 04-15-2020, 09:31 PM

RE: Early 16B tombstone - by Radioroslyn - 04-17-2020, 04:01 PM

RE: Early 16B tombstone - by morzh - 04-17-2020, 04:44 PM

RE: Early 16B tombstone - by Radioroslyn - 04-19-2020, 08:56 AM

RE: Early 16B tombstone - by Radioroslyn - 05-07-2020, 10:52 AM

RE: Early 16B tombstone - by klondike98 - 05-07-2020, 12:42 PM

RE: Early 16B tombstone - by Radioroslyn - 05-07-2020, 01:39 PM

RE: Early 16B tombstone - by EdHolland - 05-07-2020, 03:21 PM

RE: Early 16B tombstone - by Radioroslyn - 05-07-2020, 04:42 PM

RE: Early 16B tombstone - by EdHolland - 05-07-2020, 09:46 PM

RE: Early 16B tombstone - by Brad Winder - 05-10-2020, 12:45 AM

RE: Early 16B tombstone - by Radioroslyn - 05-10-2020, 09:07 AM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM

Who's Online

There are currently 4731 online users. [Complete List]
» 2 Member(s) | 4729 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me