1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 43 - Filter Choke
Masonparker
Junior Member
**
Posts: 47
Threads: 10
Joined: Nov 2020
City: CHESAPEAKE State, Province, Country: VA
#7

02-22-2021, 09:14 PM
Speaker was plugged in so that was easy.  Found a loose wire and start to get B voltage readings. I attached the readings up to the 1st Det (tube 44)  .  Then a new problem the wire resistor (item 57) part # 6450 started to heat up and smoke. Unplugged and called it a night.   So can you look at the attached reading a let me know what you think and what should a do with the wire resistor.  Having a hard time giving up on this the cabinet restoration came out perfect just need the radio now 

.pdf Scan_0003.pdf Size: 478.52 KB  Downloads: 138
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 43 - Filter Choke - by Masonparker - 02-13-2021, 06:16 PM
RE: Philco 43 - Filter Choke - by Radioroslyn - 02-13-2021, 06:43 PM
RE: Philco 43 - Filter Choke - by morzh - 02-13-2021, 09:07 PM
RE: Philco 43 - Filter Choke - by Masonparker - 02-21-2021, 08:08 PM
RE: Philco 43 - Filter Choke - by Radioroslyn - 02-21-2021, 08:49 PM
RE: Philco 43 - Filter Choke - by morzh - 02-21-2021, 10:43 PM
RE: Philco 43 - Filter Choke - by Masonparker - 02-22-2021, 09:14 PM
RE: Philco 43 - Filter Choke - by morzh - 02-22-2021, 10:06 PM
RE: Philco 43 - Filter Choke - by Masonparker - 02-22-2021, 10:12 PM
RE: Philco 43 - Filter Choke - by Masonparker - 02-22-2021, 10:15 PM
RE: Philco 43 - Filter Choke - by Masonparker - 02-22-2021, 10:59 PM
RE: Philco 43 - Filter Choke - by morzh - 02-22-2021, 11:22 PM
RE: Philco 43 - Filter Choke - by Masonparker - 02-23-2021, 07:58 PM
RE: Philco 43 - Filter Choke - by Radioroslyn - 02-23-2021, 08:36 PM
RE: Philco 43 - Filter Choke - by Masonparker - 03-18-2021, 06:52 PM
RE: Philco 43 - Filter Choke - by Radioroslyn - 03-18-2021, 07:12 PM
RE: Philco 43 - Filter Choke - by Masonparker - 03-19-2021, 06:44 PM
RE: Philco 43 - Filter Choke - by Masonparker - 03-19-2021, 06:49 PM
RE: Philco 43 - Filter Choke - by Masonparker - 03-19-2021, 07:13 PM
RE: Philco 43 - Filter Choke - by Radioroslyn - 03-19-2021, 10:24 PM
RE: Philco 43 - Filter Choke - by morzh - 03-19-2021, 11:06 PM
RE: Philco 43 - Filter Choke - by Masonparker - 03-20-2021, 08:34 PM
RE: Philco 43 - Filter Choke - by morzh - 03-20-2021, 09:37 PM
RE: Philco 43 - Filter Choke - by Masonparker - 03-21-2021, 09:42 AM
RE: Philco 43 - Filter Choke - by morzh - 03-21-2021, 12:05 PM
RE: Philco 43 - Filter Choke - by Masonparker - 04-10-2021, 10:47 AM
RE: Philco 43 - Filter Choke - by Radioroslyn - 04-10-2021, 01:56 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently 4513 online users. [Complete List]
» 3 Member(s) | 4510 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration