Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

42_327 code 122 wiring mess
#6

Hi Steve and welcome,

https://philcoradio.com/library/download...20Book.pdf Most of the time code numbers noted in the service notes as to what the circuit differences are.

Your chassis looks pretty average for the small tabletop sets as Greg noted. The 1939-42 sets have the plague of rubber coated wire. Not a lot of fun to service as there's not a lot of room on the underside. If it has an oval speaker be careful with it, they're hard to come by and expensive to recone.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
42_327 code 122 wiring mess - by Steve_R - 05-30-2021, 12:27 PM
RE: 42_327 code 122 wiring mess - by Steve_R - 05-30-2021, 01:16 PM
RE: 42_327 code 122 wiring mess - by Steve_R - 05-30-2021, 03:46 PM
RE: 42_327 code 122 wiring mess - by Radioroslyn - 05-30-2021, 04:31 PM
RE: 42_327 code 122 wiring mess - by Steve_R - 05-30-2021, 05:03 PM
RE: 42_327 code 122 wiring mess - by radiorich - 05-30-2021, 08:30 PM
RE: 42_327 code 122 wiring mess - by Arran - 05-30-2021, 10:15 PM
RE: 42_327 code 122 wiring mess - by mikethedruid - 05-30-2021, 10:20 PM
RE: 42_327 code 122 wiring mess - by Patrick - 05-31-2021, 05:15 AM
RE: 42_327 code 122 wiring mess - by Steve_R - 05-31-2021, 11:29 AM
RE: 42_327 code 122 wiring mess - by klondike98 - 05-31-2021, 12:03 PM
RE: 42_327 code 122 wiring mess - by mikethedruid - 05-31-2021, 12:32 PM
RE: 42_327 code 122 wiring mess - by Steve_R - 05-31-2021, 01:28 PM
RE: 42_327 code 122 wiring mess - by Steve_R - 05-31-2021, 09:09 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Samlex heavy-Duty bench supply filter question
Hello Everyone, I have one of my Heavy-duty bench powersuplies made by Samlex it's 13.8 volt dc 20-25 amp supply. What I...radiorich — 11:24 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
It's a Glaser Sears changer which Philco's engineers thought was an upgrade over a VM, but in retrospect I'd prefer the ...jeibner — 10:39 PM
AC/DC Transformer-less Sets
Joseph, Thank you for the confirmation. I knew that there must be more to the Transformer-less AC/DC radios than the ...PeterN — 10:30 PM
AC/DC Transformer-less Sets
Good evening, folks. Power station engineer here! The east coast had pockets of DC-only power well into the twentieth...jrblasde — 10:11 PM
AC/DC Transformer-less Sets
Model 40 does not have a rectifier, so it would be a DC only model. This however does not say anything about using...morzh — 08:01 PM
AC/DC Transformer-less Sets
I was wondering if anyone knows if these AC/DC transformer-less sets were actually used on 110v DC anywhere, and when. ...PeterN — 06:35 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
Given the 1960s vintage, it is likely that the cartridge is ceramic, likely more stable. The changer looks like a Voice...MrFixr55 — 05:03 PM
Jackson 665 j2 schematic request
FIXED!daveone23 — 03:55 PM
Bakelite crack repair - what is best epoxy?
Thanks everyone. I appreciate you sharing your experience and looks like I'll work with the 24 hr two part clear epoxy....de371 — 10:25 PM
Jackson 665 j2 schematic request
Without a schematic its going to be hard tracing the wire wound spool resistors.daveone23 — 05:21 PM

[-]
Who's Online
There are currently 4110 online users. [Complete List]
» 2 Member(s) | 4108 Guest(s)
AvatarAvatar

>