removing labels

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

removing labels

fenbach
Member

Posts: 140
Threads: 28
Joined: Dec 2016
City: portland, OR

08-03-2021, 01:15 PM

I meant both/all the labels. How to remove them and where to find replacements if the originals can’t be saved.
I experimented with a chassis label because the chassis was bad. And I can’t even imagine a way to soften or dissolve the glue on a cabinet label without damaging the wood. setting a wet paper towel on a cabinet label is a bad idea. real bad. i know.

Find

« Next Oldest | Next Newest »

Messages In This Thread

removing labels - by fenbach - 07-18-2021, 11:19 PM

RE: removing labels - by fenbach - 08-03-2021, 01:15 PM

RE: removing labels - by Arran - 09-06-2021, 02:22 AM

RE: removing labels - by fenbach - 10-17-2022, 11:24 PM

RE: removing labels - by radiorich - 10-18-2022, 09:20 AM

RE: Decal Advice - by fenbach - 08-01-2021, 12:04 AM

RE: Decal Advice - by klondike98 - 08-01-2021, 10:21 AM

RE: Decal Advice - by fenbach - 08-01-2021, 10:43 PM

RE: Decal Advice - by klondike98 - 08-02-2021, 01:14 PM

RE: Decal Advice - by fenbach - 08-02-2021, 07:40 PM

RE: Decal Advice - by klondike98 - 08-03-2021, 08:48 AM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me