Seeking Advice On How To Remove And Replace Capacitors In 37-641 Bakelite Assemblies

Thread Rating:

MrFixr55
Phorum Expert

Posts: 1,032
Threads: 9
Joined: Jul 2020
City: Greenlawn State, Province, Country: NY

07-10-2024, 05:00 PM

Hi Tonym,

The following link will take you to the Phorum's Philco Library to Syl's Repair Tips:

Bakelite Capacitor Rebuild Without Desoldering – Philco Library (philcoradio.com)

Hope this helps.

This was written by Morzh, an expert on Philco radios.

"Do Justly, love Mercy and walk humbly with your God"- Micah 6:8
Best Regards,

MrFixr55

(This post was last modified: 07-10-2024, 05:02 PM by MrFixr55.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

RE: Seeking Advice On How To Remove And Replace Capacitors In 37-641 Bakelite Assemblies - by MrFixr55 - 07-10-2024, 05:00 PM

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 6449 online users. [Complete List]
» 3 Member(s) | 6446 Guest(s)