Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Model 96 cabinet veneer
#9

I am almost positive it is white or light walnut. Then stained or toned to the proper color.
Dick


Messages In This Thread
Model 96 cabinet veneer - by TGLager - 10-23-2024, 04:48 PM
RE: Model 96 cabinet veneer - by Arran - 10-23-2024, 11:08 PM
RE: Model 96 cabinet veneer - by klondike98 - 11-04-2024, 12:59 AM
RE: Model 96 cabinet veneer - by TGLager - 11-09-2024, 04:08 PM
RE: Model 96 cabinet veneer - by RodB - 11-10-2024, 10:36 AM
RE: Model 96 cabinet veneer - by TGLager - 11-10-2024, 02:40 PM
RE: Model 96 cabinet veneer - by RodB - 11-10-2024, 07:01 PM
RE: Model 96 cabinet veneer - by TGLager - 11-10-2024, 11:02 PM
RE: Model 96 cabinet veneer - by madsowry - 11-12-2024, 09:58 PM
RE: Model 96 cabinet veneer - by TGLager - 11-13-2024, 09:19 PM
RE: Model 96 cabinet veneer - by Arran - 11-16-2024, 03:25 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

[-]
Who's Online
There are currently 1850 online users. [Complete List]
» 1 Member(s) | 1849 Guest(s)
Avatar

>