16B

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

16B

Steve Davis
Phorum Expert

Posts: 1,402
Threads: 70
Joined: Oct 2007
City: Linn Creek, MO

11-14-2011, 09:47 AM

Joe, I'm with Arran on this one. Remove the wrap around so you can re-veneer it as a flat piece. I use the yellow wood glue, slightly thinned. Apply the glue to both the wrap and the veneer, then clamp between two boards. You might consider just replacing the wrap around.

Steve

M R Radios C M Tubes

Find

« Next Oldest | Next Newest »

Messages In This Thread

16B - by w4rtc - 11-06-2011, 09:49 PM

Re: 16B - by thirtiesradio - 11-07-2011, 11:52 PM

Re: 16B - by Arran - 11-08-2011, 01:30 AM

Re: 16B - by Steve Davis - 11-14-2011, 09:47 AM

Re: 16B - by thirtiesradio - 11-19-2011, 11:53 PM

Re: 16B - by Arran - 11-20-2011, 12:57 AM

Re: 16B - by thirtiesradio - 11-21-2011, 12:14 AM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 6815 online users. [Complete List]
» 1 Member(s) | 6814 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me