1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 90 Oscillator Resistor Question
Joe
Junior Member
**
Posts: 31
Threads: 5
Joined: Feb 2012
#1

02-10-2012, 07:59 AM
Can anyone tell me if I should replace the 5000 ohm resister that feeds the #27 osc tube with a lower value? I'm asking because on a website http://www.rickstuberadios.com/ he mentions that the rushing noise in his Philco 89 was due to the 15,000 ohm resister resistor that fed the #36 tube osc changing to a higher value.

He changed the 15K to 7.5K. I am getting a rushing noise & drop in volume in my Philco 90 similar to what was described on the website & I was wondering if I should change my 5K resistor to say 3K. Any one else have this problem or familiar with it?

My Philco 90 is the type with one #47 tube

Thanks......Joe!
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 90 Oscillator Resistor Question - by Joe - 02-10-2012, 07:59 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM
40-150 General questions
It's most likely a part number. Most of Philco part numbers are in that format. I looked at the parts list for this mode...RodB — 08:10 AM
40-150 General questions
Hi Kevin, No, I don't but I like your Quote about being a good electrician. The way I look at it is "The fact ...MrFixr55 — 08:06 AM

[-]
Who's Online
There are currently 3329 online users. [Complete List]
» 3 Member(s) | 3326 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration