Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 46-806 audio out
#7

The AC/DC 46-806 has a ballast resistor which could be inserted one of two ways in its socket. When the set is operated in the 230 volt position, extra resistance drops the line voltage to 115; in the 115 position, a jumper wire allows the full line voltage to be used in the set.

I have a 46-806 which uses one of these ballasts. My 42-761 also uses a two way ballast - different type than the 46-806, though.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Philco 46-806 audio out - by henrypal - 02-11-2013, 01:51 PM
RE: Philco 46-806 audio out - by 7estatdef - 02-11-2013, 02:11 PM
RE: Philco 46-806 audio out - by henrypal - 02-11-2013, 02:43 PM
RE: Philco 46-806 audio out - by 7estatdef - 02-11-2013, 07:07 PM
RE: Philco 46-806 audio out - by Ron Ramirez - 02-11-2013, 07:13 PM
RE: Philco 46-806 audio out - by Ron Ramirez - 02-12-2013, 06:52 AM
RE: Philco 46-806 audio out - by henrypal - 02-12-2013, 12:38 PM
RE: Philco 46-806 audio out - by wa2ise - 02-15-2013, 10:25 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 3281 online users. [Complete List]
» 1 Member(s) | 3280 Guest(s)
Avatar

>