1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 38-62 restoration
jerryhawthorne
Phorum Expert
*****
Posts: 1,562
Threads: 56
Joined: Nov 2008
City: Sedona, AZ/Placentia/CA
#16

03-03-2013, 05:40 PM
Bob, that radio chassis looks great. I wouldn't mess with it. Nice job on the "old lady", she should show a little of her age. As for the TV chassis, that looks terribly nice. I can't imagine doing that deep a teardown but then again, it looked like it had seen a lot of mouse activity. You are very talented.
Jerry
A friend in need is a pest!  Bill Slee ca 1970.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 38-62 restoration - by Bob Andersen - 02-21-2013, 06:25 PM
RE: Philco 38-62 restoration - by Arran - 02-21-2013, 07:14 PM
RE: Philco 38-62 restoration - by klondike98 - 02-21-2013, 09:43 PM
RE: Philco 38-62 restoration - by Arran - 02-21-2013, 10:22 PM
RE: Philco 38-62 restoration - by Bob Andersen - 02-21-2013, 10:57 PM
RE: Philco 38-62 restoration - by Bob Andersen - 02-22-2013, 12:56 AM
RE: Philco 38-62 restoration - by Arran - 02-22-2013, 02:36 AM
RE: Philco 38-62 restoration - by Bob Andersen - 02-22-2013, 05:27 PM
RE: Philco 38-62 restoration - by Bob Andersen - 03-02-2013, 12:39 AM
RE: Philco 38-62 restoration - by Phlogiston - 03-02-2013, 01:14 PM
RE: Philco 38-62 restoration - by morzh - 03-02-2013, 10:32 PM
RE: Philco 38-62 restoration - by Bob Andersen - 03-03-2013, 12:35 AM
RE: Philco 38-62 restoration - by Ron Ramirez - 03-03-2013, 08:58 AM
RE: Philco 38-62 restoration - by morzh - 03-03-2013, 09:52 AM
RE: Philco 38-62 restoration - by codefox1 - 03-03-2013, 12:57 PM
RE: Philco 38-62 restoration - by jerryhawthorne - 03-03-2013, 05:40 PM
RE: Philco 38-62 restoration - by Bob Andersen - 03-03-2013, 05:53 PM
RE: Philco 38-62 restoration - by Tom Hamilton - 03-23-2013, 09:31 PM
RE: Philco 38-62 restoration - by Bob Andersen - 03-24-2013, 12:21 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 3794 online users. [Complete List]
» 2 Member(s) | 3792 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration