1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Threaded Mode
My new RCA 6T-7 tombstone
Dan Walker
Senior Member
****
Posts: 371
Threads: 103
Joined: Jul 2011
City: Calgary, AB, CA
#16

02-08-2016, 02:06 PM
   Warm to me is when I can do some work in the garage and not have cold hands. I guess about 60 F would be good.
  It is supposed to get to get to 50F this week, but I have all my stripping stuff in the house. 
I have all my Mohawk products,  lacquer, stripper,  shellac and touch up stuff  in the basement and I don't want to take it out until it does not freeze at night.. It still freezes every night.
Ideally  I like to do this sort of stuff when it is about 75F.
   Living in Calgary Alberta
Find
« Next Oldest | Next Newest »




Users browsing this thread: 9 Guest(s)
[-]
Recent Posts
38-690 on ebay
I saw this 38-690 close on ebay at a great $.  If you hadn't seen it bodes well for values imo. Not sure if this is the...poulsbobill — 12:34 PM
Philco 38-690 input jack
I have not done this on a 38-690.  I don't own one but in general, the best place to add the input is right at the volum...MrFixr55 — 11:12 AM
Dynamic Speaker Information
Oh, what a clever solution for hum! Thanks, Ron!jrblasde — 09:42 AM
462ron
The B.C. is the bucking coil or hum bucking coil. It’s in series with the output transformer secondary and the voice coi...462ron — 09:21 AM
Dynamic Speaker Information
Good morning, folks:     I have a question about dynamic speakers. I’ve got two sets that feature one—a 46-480 and a ...jrblasde — 08:14 AM
Any Philcos that contain asbestos?
I wonder if trisodium phosphate has any antiseptic qualities, it's very good at removing crud and oxidation from some me...Arran — 01:30 AM
Philco 60 restoration
Was about to install the can back, but one of the screws would not tighten. It developed some mushed therad. Would noty ...morzh — 10:09 PM
Philco 38-690 input jack
Wanting to install an input jack in my 38-690. Has anyone did this on a 690?supertech — 10:04 PM
Philco 60 restoration
Yes, I do not know why but all radios I have restored, with this type tone control, had rubber wires going to it. The f...morzh — 10:44 AM
Philco 60 restoration
I recently finished restoring a 66 in the very same cabinet. Very nice sounding radio. Funny how just about every radio ...dconant — 09:23 AM

[-]
Who's Online
There are currently 375 online users. [Complete List]
» 1 Member(s) | 374 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)