Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

marconi 157
#1

I picked a Marconi model 157 radio and when I got it the radio had a capacitor hum only so I recapped it and now I have a motor boating sound from half volume and up and no other sound only a low hum
#2

Assuming that all of the capacitors were installed correctly, check the values of all of the resistors in particular a canned-ohm if it has one.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#3

See if any tubes and their grid wires that are supposed to be encased in a shield are inside the shield.

Also: have you tested the tubes?

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#4

(11-19-2016, 11:51 AM)Phlogiston Wrote:  Assuming that all of the capacitors were installed correctly, check the values of all of the resistors in particular a canned-ohm if it has one.

I am not sure what a canned ohm resistor is but I will check the others
#5

(11-19-2016, 12:47 PM)morzh Wrote:  See if any tubes and their grid wires that are supposed to be encased in a shield are inside the shield.

Also: have you tested the tubes?
tubes have been tried in working radios and none of the tubes at all have shields
#6

(11-19-2016, 01:57 PM)the picker Wrote:  
(11-19-2016, 11:51 AM)Phlogiston Wrote:  Assuming that all of the capacitors were installed correctly, check the values of all of the resistors in particular a canned-ohm if it has one.

I am not sure what a canned ohm resistor is but I will check the others

It is the voltage divider resistor from which is derived the bias voltages. It is often a wire-wound in a metal sleeve riveted to the chassis for heat dissipation. The wire can burn open but most often the contacts become intermittent.

In most of my recent repairs, I would estimate that 1/2 to 2/3 of all resistors had either failed or were way out of tolerance.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#7

Here's schematic for anyone helping.
http://pacifictv.ca/schematics/marconi157data.pdf
#8

Russ might've meant Candohm.
It is a power resistor that is riveted to a chassis.


Ypi don't seem to have one.
Your neg bias seems to be made with a.... battery?
Is the battery good?

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
#9

(11-19-2016, 03:25 PM)morzh Wrote:  Russ might've meant Candohm.
It is a power resistor that is riveted to a chassis.


Ypi don't seem to have one.
Your neg bias seems to be made with a.... battery?
Is the battery good?
are you talking about the 1.5 v bias cell if so yes I have it replaced
#10

candohm resister  looks like this
[Image: http://i117.photobucket.com/albums/o46/r...de8706.jpg]
could be smaller or larger with more tabs

Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2
#11

(11-19-2016, 04:21 PM)sam Wrote:  candohm resister  looks like this
[Image: http://i117.photobucket.com/albums/o46/r...de8706.jpg]
could be smaller or larger with more tabs

I will look but I do not think it has one
#12

I don`t think you have one

Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2
#13

(11-19-2016, 05:07 PM)sam Wrote:  I don`t think you have one
I looked and could not see one .
#14

Well, they look canned.

So never mind that, but check the voltages on the tubes starting with the 6F6.

Just curious too, does the eye tube do anything (signal indication)?

Do you have a signal tracer?

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#15

For us US guys here's some pic's of it:   http://radioatticarchives.com/radio.htm?radio=12521

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry




Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Hi Morzh, May be a good idea to remove the cone to prevent damage. You may have to do so anyway to remove the pole ...MrFixr55 — 08:44 PM
Philco 91 Restore Code ??
I think that Danaher, the company that owns Beckman-Coulter (the company that I worked for 41 years) owns Fluke. They a...MrFixr55 — 08:35 PM
Philco 91 Restore Code ??
Rod I wish... :lol: I am not sure I'd buy the Fluke, had it not fell in my lap for free. $500 to $800...it's a lot...morzh — 08:09 PM
Philco 91 Restore Code ??
Mike, ...you get a commission?RodB — 07:52 PM
New member
Hi. I specialize in refurbishing Predictas, but I'm in Chicago. If you can get it to me, I'd be happy to go over it. ...Bob Andersen — 06:43 PM
An attempt to remove the Field Coil from a G speaker
I have 3 G speaker, all with open Field coils. Today I pull one of the shelf and decided to try to remove the FC (spo...morzh — 06:07 PM
Philco 91 Restore Code ??
Thanks Mike. I will check them out.dconant — 05:52 PM
Philco 91 Restore Code ??
There is no such thing as bad Fluke. This said, they are expensive. A Fluke is easily 10x the price of comparable CCC...morzh — 05:45 PM
Philco 91 Restore Code ??
Hello Mike, Yes, I have 3 Fluke meters one being my first Fluke 77 and other being Fluke 87. My third is Fluke clamp -...radiorich — 05:04 PM
Philco 91 Restore Code ??
I knew that Fluke was the Cadillac so with that in mind what Fluke would you recommend I get?dconant — 03:53 PM

[-]
Who's Online
There are currently no members online.

>