46-1201

Thread Rating:

1 Vote(s) - 1 Average
1
2
3
4
5

Threaded Mode

46-1201

cougar01
Junior Member

Posts: 7
Threads: 3
Joined: Mar 2018
City: Butler, Pa

02-19-2019, 05:07 PM

Planning on restoring a Model 46-1201 (Build 125) Bing Crosby in a few months, and am trying to locate a few parts beforehand. I found on another post the part number for a replacement Idler Wheel for the M-7 turntable. However, has anyone found a suitable replacement for the 2 "sleeves" on the guide rollers? Mine appear quite worn, and have seen better days. If there was a replacement available, I'd like to swap those out. I also have info from other posts regarding the needle assembly in case I need to change cartridges. Any other issues with these units that I should be aware of ahead of time other than the standard replacement of caps and any resistors as needed? Thanks!

(This post was last modified: 02-19-2019, 05:20 PM by cougar01.)

Find

« Next Oldest | Next Newest »

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM

Who's Online

There are currently 3173 online users. [Complete List]
» 1 Member(s) | 3172 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me