Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

NY radio makers?
#1

How may I find the name of companies making Broadcast radios in New York State during the time from 1930 to 1932?

Regards,
Steve
stephentetorka@cs.com
#2

Hi Steve,

I don't have anything specifically for the period 1930-1932, but I do have a 1944 Sylvania Tube Complement Manual which lists the following receiver manufacturers in the State of NY in 1944:

Air King Products Co. (Brooklyn)
Allied Engineering Institute (NYC)
American Communications Corp. (NYC)
Amplex Radio Corp. (NYC)
Andrea Radio Corp. (Woodside, L.I.)
Ansley Radio Corp. (NYC)
Bell Radio & Telev. (NYC)
Brunswick Radio Div., Mersman Bros. Corp. (NYC)
Canton Trading Co. (NYC)
Colonial Radio Corp. (Buffalo)
Dewald Radio Mfg. Corp. (NYC)
Dictograph Products Co., Inc. (NYC)
Eastern Radio Specialty Co. (NYC)
Emerson Radio & Phonograph Corp. (NYC)
Espy Mfg. Co. (NYC)
Fada Radio & Electric Co. (Long Island)
Federated Purchasers, Inc. (NYC)
Ferguson Radio & Television Co. (NYC)
Finch Telecommunications, Inc. (NYC)
Freed Mfg. Co. (NYC)
Freely Corp. (NYC)
Garod Radio Corp. (NYC)
General Television & Radio Corp. (NYC)
Grebe Mfg. Co., Inc. (NYC)
Gross Radio, Inc. (NYC)
Hammarlund Mfg. Co. (NYC)
Jefferson-Travis Radio Mfg. Corp. (NYC)
Karns-White Corp. (NYC)
Lafayette Radio Corp. (NYC)
La Salle Radio Corp. (NYC)
Luxor Radio Mfg. Co. (NYC)
Mansley Radio Corp. (Baldwin)
Marconiphone, Inc. (NYC)
Marine Radio Corp. (Jamaica)
Namco Mfg. Co., Inc. (NYC)
Pacent Engineering Corp. (NYC)
Philmore Mfg. Co. (NYC)
Pilgrim Electric Corp. (NYC)
Pilot Radio Corp. (Long Island, NYC)
Port-O-Matic Corp. (NYC)
Presto Recording Corp. (NYC)
Radio Constructors Labs (NYC)
Radiomarine Corp. of America (NYC)
Radio Supplies (NYC)
Radio Transciever Labs (Richmond Hill)
Radio Wire Telev., Inc. (NYC)
Regal Amplifier Mfg. Corp. (NYC)
Sara Co. (NYC)
Savil Radio Engineering Corp. (NYC)
Sillcox Radio & Telev. Corp. (NYC)
Sky Chief Radio Corp. (NYC)
Sonora Elec. Phonograph Co., Inc. (NYC)
Stromberg-Carlson Tele. Mrg. Co. (Rochester)
United Cinephone Corp. (NYC)
United States Telev. Mfg. Corp. (NYC)
Universal Tube Mfg. Co. (Brooklyn)
Westinghouse Electric Supply Co. (NYC)


This list includes New York State only. Many others just across the border, such as RCA Mfg. Co. at Camden, NJ.

It is impossible to say just how many of the above actually manufactured their own receivers, and how many were buying either full or partially-assembled sets from others.

As mentioned, this list is from 1944. Most likely a list from 1930-1932 would be much longer, as many companies folded during the Depression.

The only State even remotely approaching New York in number of radio manufacturers was Illinois, and those were almost all either in or near Chicago.

Poston
#3

Hi Poston:

Thank you for the very helpful info.

Now I have to find a 1931 New York mfg. 7-tube radio whose antenna enters via a 235 whose grid and plate are grounded...with the ant signal going to that 235 cathode....closest I've found is a Delco...but that's not NY.

Regards,
Steve




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently 3688 online users. [Complete List]
» 1 Member(s) | 3687 Guest(s)
Avatar

>