Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Remler wood console
#1

   

I found this on craigslist for $80. I can't seem to find any info on Remler wood consoles. I found lots of stuff about their table bakelite units. Anybody have any info about this? And maybe if it's a good buy?

Thanks,

Pat
#2

If it is clean inside...maybe. Provided the speaker is good.
#3

Looks like it might be an amputee though...

No matter where you go, there you are.
#4

It has a short.............................cabinet.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
#5

(11-08-2014, 09:21 PM)Phlogiston Wrote:  It has a short.............................cabinet.

So do I. But I think I'll pass. Thanks to you all.
#6

  Given the weekend warrior refinish, the missing legs, broken escutcheon, broken speaker grille, mystery knobs, $80 is way to much, maybe $30-40 tops, if it had everything still in the back, but preferably less. As I keep explaining to people, it's the restoration costs in time and money that nails you, sometimes even if the radio is free it's too much.
Regards
Arran
#7

(11-09-2014, 03:11 AM)Arran Wrote:    Given the weekend warrior refinish, the missing legs, broken escutcheon, broken speaker grille, mystery knobs, $80 is way to much, maybe $30-40 tops, if it had everything still in the back, but preferably less. As I keep explaining to people, it's the restoration costs in time and money that nails you, sometimes even if the radio is free it's too much.
Regards
Arran

I agree 100%. My time isn't worth much because it's a hobby, and caps and resistors are cheap, but the rest can cost an arm and a leg, and you'll never be able to sell it for more than you have invested. I used to restore classic cars as a hobby, and if you weren't careful, you could put $25,000 into a car, and only sell it for $20,000. At least with this hobby, my bank account doesn't suffer as much, and my wife lets me sleep in the bedroom rather than the garage.




Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently no members online.

>