Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Marconi 138
#1

  I just bought this Marconi model 138. I really like the rogers and Marconi consoles.. They have those large dials and this one has 14 dial lights. I have it recapped and it does have a very clear and nice sound.. The cabinet will have to wait until spring and it is going to need some extensive work on the top.
  I may bring it in and do the repairs on the top during the winter. All the knobs are there but the grill cloth is shot.


Attached Files Image(s)
               

   Living in Calgary Alberta
#2

Those Canadian sets are way cool!
#3

Looks good Dan. Those Marconi sets have really big sound. The cabinet repairs don't look too intimidating. A few veneer chips, maybe a bit of veneer lift and a lot of flaking lacquer. It will look beautiful when you are done.

cheers

John
#4

(10-10-2015, 07:46 AM)John Bartley Wrote:  Looks good Dan. Those Marconi sets have really big sound. The cabinet repairs don't look too intimidating. A few veneer chips, maybe a bit of veneer lift and a lot of flaking lacquer. It will look beautiful when you are done.

cheers

John
   Thanks  John. It looks better than it is ..
  You make it sound so simple.  All those light colored lines running from front to rear,on the top are lifted veneer. It should be relatively easy to repair, but it just takes time.
  It  Will be worked on this winter.
  Dan in Calgary

   Living in Calgary Alberta




Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM
40-150 General questions
It's most likely a part number. Most of Philco part numbers are in that format. I looked at the parts list for this mode...RodB — 08:10 AM
40-150 General questions
Hi Kevin, No, I don't but I like your Quote about being a good electrician. The way I look at it is "The fact ...MrFixr55 — 08:06 AM

[-]
Who's Online
There are currently 2745 online users. [Complete List]
» 3 Member(s) | 2742 Guest(s)
AvatarAvatarAvatar

>