04-21-2021, 09:11 PM
Hi! New user here! And not too experienced in refurbishing old radios. I've done a few...but they were not in bad condition.
Working on a 41-608 Code 122. The turntable is in poor condition. I noted on your post your ordered new idler wheels from "VM". Can I get more details please? I have two black wheels that are "dented" - like the table was stuck and the shaft just wore a dent in them.
Also, the center gear (brown, plastic) is missing some teeth. I think it will still work, but I'd replace it if I could find the right part.
Looks like I'll have some work on the pickup as well - still evaluating that and haven't tested the light or sensor yet. I'll wait until I get the recap done. Looks like some great ideas on this forum!
Any guidance on getting parts, etc. is deeply appreciated.
Thanks,
Gary
Working on a 41-608 Code 122. The turntable is in poor condition. I noted on your post your ordered new idler wheels from "VM". Can I get more details please? I have two black wheels that are "dented" - like the table was stuck and the shaft just wore a dent in them.
Also, the center gear (brown, plastic) is missing some teeth. I think it will still work, but I'd replace it if I could find the right part.
Looks like I'll have some work on the pickup as well - still evaluating that and haven't tested the light or sensor yet. I'll wait until I get the recap done. Looks like some great ideas on this forum!
Any guidance on getting parts, etc. is deeply appreciated.
Thanks,
Gary
