Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

48-472-122 FM issue
#1

Hello Everyone,

I'm working on a really nice 48-472=122. I replaced all caps, tested resistors and tubes, aligned. The problem is, AM works fine. Fm, not so good. I can pick up my local stations fine except that they are very faint. Until I put a screwdriver to pin #8 of the 14F8. Then the volume goes up to a normal level. Any thoughts?


.pdf usa_philco_48472_sch1a.pdf Size: 69.67 KB  Downloads: 132
.pdf usa_philco_48472_sch1b.pdf Size: 57.3 KB  Downloads: 108



Thanks,

Eric
The Villages, FL
Member: Philco Phorum, ARF, ARCI & Radiomuseum.org



Messages In This Thread
48-472-122 FM issue - by Eric Adams - 02-14-2019, 04:25 PM
RE: 48-472-122 FM issue - by PhilcoMike - 02-14-2019, 04:47 PM
RE: 48-472-122 FM issue - by Eric Adams - 02-14-2019, 04:54 PM
RE: 48-472-122 FM issue - by PhilcoMike - 02-15-2019, 04:50 PM
RE: 48-472-122 FM issue - by Radioroslyn - 02-15-2019, 08:18 PM
RE: 48-472-122 FM issue - by Eric Adams - 02-20-2019, 11:32 AM
RE: 48-472-122 FM issue - by EdHolland - 02-20-2019, 02:47 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 7259 online users. [Complete List]
» 3 Member(s) | 7256 Guest(s)
AvatarAvatarAvatar

>